Paver Specifications

PAVER SPECIFICATIONS

101.60mmx203.20mm Composite Paver

101.60mmx203.20mm Composite
Permeable Paver

101.60mmx203.20mm Composite
Resurfacing Paver

Applications

Resurface Existing Concrete

•

Resurface Existing Decking

•

Flat Roofs

•

Stormwater Management

•

Driveways

•

Parking Lots

•

Patios

•

Sidewalks

•

Pool Areas

•

Other Low Speed Vehicle Traffic

•

IMPORTANT: AZEK Pavers are not intended for use near, or under, in-ground fire pits. A minimum of four feet must be maintained between an open fire. Portable fire pits, charcoal and gas grills may be used ontop of the pavers. We recommend using a fire proof mat to protect any potentional scarring to the product.

Material

AZEK Composite Masonry: Up to 95% recycled material including recycled scrap tire rubber and plastics.

Maintenance

AZEK Pavers require virtually no maintenance other than an occasional replenishment of joint sand. Chemical spills (e.g. petroleum, paint) should be cleaned as soon as possible with an appropriate industrial cleaner and rinsed thoroughly with water. Chemical spills or stains left untreated over long periods of time may degrade the surface finish and integrity of the product and are not covered under warranty.

101.60mmx203.20mm Composite Paver

101.60mmx203.20mm Composite
Permeable Paver

101.60mmx203.20mm Composite
Resurfacing Paver

Sizes (W x L x H)

Paver

101.60mm x 203.20mm x 50.292mm

87.630mm x 203.20mm x 50.292mm

101.60mm x 203.20mm x 31.242mm

Grid

406.40mm x 406.40mm x 22.860mm

406.40mm x 406.40mm x 25.400mm

Combined Height

60.452mm

44.450mm

Each Unit

One Unit

8 Pavers, 1 Grid

Weight (per unit)

7.302837 kg

6.713167 kg

5.125594 kg

Square Feet (per unit)

0.1653674 sq.m

Pallet Sizes

Quantity per Pallet

126 units
(approx. 20.8103 sq.m)

180 units
(approx. 29.729 sq.m)

Weight per Pallet

approx. 952.544 kg

approx. 870.8974 kg

approx. 952.544 kg

Colors

Redwood, Boardwalk, Waterwheel

Laser Engraving

Yes

101.60mmx203.20mm Composite Paver

101.60mmx203.20mm Composite
Permeable Paver

101.60mmx203.20mm Composite
Resurfacing Paver

Test Data

Compressive Strength

ASTM C140-09 Section 7
Peak Comp. Strength: >2000 psi
(Note: in “bound” configuration)

Not Tested

Flexural Strength

ASTM C140-09 Annex A6
Ult. Flex. Strength: 695 psi (stdev 35 psi)
Flexural Modulus: 3842 psi (stdev 380 psi)

Not Tested

Coefficient of Friction

ASTM C1028-07 (neolite pad)
Dry (static): 0.99
Wet (static): 0.67

ASTM D2394-05e1 (leather sole)
Dry (static): 0.57 Dry (sliding): 0.46
Wet (static): 0.94 Wet (sliding): 0.86

Coefficient of Thermal Expansion

44*10^(-6) at 68 degF

Flame Spread

UL 94 Section 7 (material test)
Horizontal burning rate: 51 mm/min (2.0 in/min)

Note: A chemical shall be considered a flammable solid if, when tested by the method described in 16 CFR 1500.44, it ignites and burns with a self-sustained flame at a rate greater than one-tenth of an inch per second (6.0 in/min) along its major axis. Testing via UL 94 Section 7, AZEK Pavers has observed a flame spread rate that is roughly one-third the limit recognized by the Code of Federal Regulations.

Flame Spread

ASTM E108-007 (tested at 1/2:12 slope)
Spread of Flames: Class “C”
Intermittent Flame: Class “C”
Burning Brand: Class “C”

Note: Laboratory results only; not certified by U/L; test performed on equivelant product; slight variations in test performance may result

Xenon Arc Weathering

ASTM G155
2,000+ hours (please refer to the AZEK Pavers weathering chart for color retention expectations)

Chemical Resistance

No visual discoloration after 30 day exposure to household bleach or muriatic acid.
No known discoloration due to exposure to road/deicing salt (sodium chloride), engine oil, grease and common household cleaners.

Cold Water Absorption

ASTM C67 Section 8 (material test)
PASS: <1% by mass, average saturation coefficient (after 1 hour boil): 0.05

Freeze-Thaw Cycling

ASTM C67 Section 9 (material test)
PASS: freeze-thaw cycled 52 times over 75 days. No visual signs of cracking, warping or crazing.

Infiltration Rate

Not Tested

With ASTM No. 8
(3/8-” trap rock): >480 in/hr
(>4.9 gal/min)
Open Area: 12%

Not Tested

Specifications are subject to change without notice. Due to the innovative aspects of the AZEK Pavers many of the industry standardized test practices were modified to accommodate material and design features unique to this product. For complete testing details, please contact AZEK.